1. Registering for the Forum

    We require a human profile pic upon registration on this forum.

    After registration is submitted, you will receive a confirmation email, which should contain a link to confirm your intent to register for the forum. At this point, you will not yet be registered on the forum.

    Our Support staff will manually approve your account within 24 hours, and you will get a notification. This is to prevent the many spam account signups which we receive on a daily basis.

    If you have any problems completing this registration, please email support@jackkruse.com and we will assist you.

Have you seen this video about smart meters?

Discussion in 'The EMF Rx' started by Hope, Jun 13, 2013.

  1. Hope

    Hope Gold

    No surprise....but still wanted to share. I have friends who grew up in East Germany and Russia and I am pretty sure they would be scared to see this....either that or think this is a joke. This can't be happening for real, right?

    http://www.youtube.com/watch?v=8JNFr_j6kdI&feature=youtu.be
     
    Last edited: Jun 13, 2013
  2. Lava

    Lava Gold

    Good video...thanks....The power company was at our home yesterday and wanted to put an "earth meter" on. I asked if it was the same as a smart meter and he said no. I can find no info on an "earth meter." Was he lying?
     
  3. Danco3636

    Danco3636 Silver

    Nice video.
     
  4. Hope

    Hope Gold

    Lava, have you called the company?? Perhaps whoever came by just didn't know or whatever? I'd definitely find out and try to opt out if i were you. Scary stuff, indeed....I wanna live on a desert island.
     
  5. kathylu

    kathylu Gold

    I'm more concerned about the EMF than I am about the political implications.
     
  6. Dextery

    Dextery New Member

    You can shield your meter by the following cheap fix:

    For $10, everyone can shield their smart meter. Get a one gallon paint can, clean it up or buy an unused one at home depot. Also buy a small role of aluminum screening and also buy two 7 inch hose clamps. Cut the bottom out of the paint can and place it over the meter. Use one of the hose clamps to secure it to the smart meter. The can is a little larger than the meter. The can will bulge a bit when secured tightly. Then cut a piece of the aluminum screening that will fit over the end of the can facing away from the wall it is mounted on. Use the other hose clamp to secure the screen material. Trim as necessary. Take the remaining screening material and mount it behind the meter on the back side of the wall the meter is attached to. This prevents the emf from the meter radiating back through the wall as the meter is omnidirectional. The meter can still transmit your electrical usage to the power company. For people with the meter mounted on a pole or elsewhare, get the aluminum screening and drape the screen over the meter and all around the back side of the pole.
    You are now shielded 95%. I don't have an emf meter, but the youtube videos I have seen do things similar to this and they block the radiation quite well.

    Edit: You also need to ground the paint can with a wire. I just slip one bare end under one of the hose clamps and then run it down to a piece of copper wire I bought from Home Depot...about 3 ft...buried it with the grounding wire attached.
     
    Last edited: Oct 16, 2013
  7. Jack Kruse

    Jack Kruse Administrator

    post a video.........please.
     
  8. Dextery

    Dextery New Member

    Here are three. Have to run now but will be back with a few more videos.

    https://www.youtube.com/watch?v=cmS5pVEZHzg
    https://www.youtube.com/watch?v=CL2JQ0FbgvU
    https://www.youtube.com/watch?v=EoM43CXB4FY
    https://www.youtube.com/watch?v=LN10megpzLM This video talks about grounding your shield. I have not done that yet but that is my project for tomorrow.
    https://www.youtube.com/watch?v=uoRtC0e9Rm0

    The last video shows a man doing muscle testing to demonstrate how debilitating the RF from a smart meter is. For those of you who have been treated by a kinesologist, muscle testing is a way the practitioner can idenitify weak parts of the body and directs them to where a spine adjustment should be made. And he demonstrates how very important it is to shield the back side of the meter. He also uses a salt lamp and/or salt crystals to block the emf. Not so sure about that method but it seems to work.

    Shield your meter so the RF is tearing your cells apart.
     
    Last edited: Jun 14, 2013
  9. GlenPDQ

    GlenPDQ New Member

    Sounds like word play to me. Maybe the power company is brandishing words that had a positive result with the focus group. Next they will start calling it a Green Meter.
     
  10. Terminator

    Terminator New Member

    My brother who was a huge skeptic about EMF's from any wireless device is now becoming a believer. His girls that sleep in the room that has the draconic wireless meters on outside wall have constant headaches since it's been installed. He has a friend that works for DTE who installes these meters. His fried stated that there are many reporting same thing and that these meters are more than just simply usage recording devices, they are used to spy on us. DTE employee confirmed this.
     
  11. fitness@home

    fitness@home Silver

    Marcoc, are you by any chance a Michigan resident? I worked at DTE facility (Fermi 2) for 10 years.
     
  12. Terminator

    Terminator New Member

    Yes, i'm a Michigan resident.
     

Share This Page